Grundfos MAGNA3 40-120 F High-Efficiency ECM Smart Circulator
Grundfos MAGNA3 40-120 F High-Efficiency ECM Smart Circulator
National Boiler Supply is a premier, authorized procurement distributor for high-efficiency commercial equipment. Every order ships factory-direct, completely insured, and backed by full manufacturer engineering warranties and technical field support.
| Performance Parameter | Engineering Baseline Value |
|---|---|
| Manufacturer Part Number (MPN) | 98126832 (Quoted Active Configuration) |
| Pump Type | Wet-Rotor Smart Circulator Pump (ECM) |
| Port/Flange Size | 1-1/2" Flanged (40 mm / 4-bolt configuration) |
| Maximum Head / Max Pressure | 39 ft of Head / 175 PSI (12 bar) |
| Fluid Temperature Range | 14°F to 230°F (-10°C to 110°C) |
| Electrical Input / Voltage | 1-Phase (208-230V) 50/60Hz |
| Pump Housing Metallurgy | Cast Iron (EN-GJL-250) |
| Impeller Material | Composite (PES 30% GF) |
Couldn't load pickup availability
📋 Procurement & Logistics Notice
Fulfillment parameters vary based on active supply chain distributions and contract schedules:
- Standard inventory configurations typically dispatch within 24 to 48 hours.
- High-capacity commercial units or specialty phase requirements may face factory production lead times.
Need precise lead times, formal submittals, or shipping coordination for contract fulfillment? Please Request a Commercial Quote or contact our procurement support line.
Corporate Procurement & PO Processing
Formal Purchase Orders (POs) and tax-exempt ordering are accepted for commercial contractors and institutional facilities.
Apply for Trade Account & Terms →Grundfos MAGNA3 40-120 F High-Efficiency ECM Smart Circulator
Engineered for light-to-medium commercial heating, chilled water cooling, and domestic hot water recirculation loops, the Grundfos MAGNA3 40-120 F is an intelligent, wet-rotor smart circulator pump built to deliver maximum hydraulic performance with minimal electrical power consumption. Driven by a cutting-edge permanent-magnet motor (ECM) and a fully integrated frequency controller, this pump continuously reads your hydronic network to automatically establish the most efficient operating speed, reducing electricity costs by up to 75% compared to traditional fixed-speed pumps.
The MAGNA3 40-120 F leverages Grundfos’s proprietary AUTOADAPT and FLOWADAPT technologies, which dynamically adapt the pump's performance curve to match moving system demands without needing manual balancing or engineering recalculations. Outfitted with an on-board heat energy tracking meter, wireless multi-pump synchronization for master/slave setups, and full capability to integrate into modern building automation systems (BMS), it represents the pinnacle of modern B2B hydronic distribution technology.
Key System Performance Baselines:
- Dynamic System Tuning: Built-in AUTOADAPT algorithms continually map the system load profile, optimizing flow delivery and eliminating the noise and pressure spikes caused by changing zone valves.
- Advanced ECM Efficiency: High-torque permanent-magnet motor architecture vastly reduces ongoing operating expenses and seamlessly satisfies strict commercial energy standards.
- On-Board Energy Auditing: An internal thermal calculator approximates system heat energy utilization over time, removing the need for costly external instrumentation loops.
- Flange Configuration: Designed with a standard 40mm inline cast iron flanged connection point, perfect for rapid, clean installation into standard commercial piping manifolds.
⚠️ Application Profile: This MAGNA3 circulator configuration is highly optimized for primary heating circuits in commercial properties, secondary hydronic mixing zones, chilled water fan coil supply lines, and solar thermal energy capture networks.
Product Documents
